हिंदी

State the correction if the positive error is 7 divisions when the least count is 0.01 cm.

Advertisements

प्रश्न

State the correction if the positive error is 7 divisions when the least count is 0.01 cm.

संख्यात्मक
Advertisements

उत्तर

When positive error is 7 divisions and L.C. is 0.01 cm
Then correction = – (+ 7 × L.C.)
= −7 × 0.01 cm
= – 0.07 cm

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
अध्याय 1: Measurements and Experimentation - Unit 3 Exercise 3

APPEARS IN

गोयल ब्रदर्स प्रकाशन A New Approach to ICSE Physics [English] Class 9
अध्याय 1 Measurements and Experimentation
Unit 3 Exercise 3 | Q 7.3

संबंधित प्रश्न

Name the part of the vernier callipers which is used to measure the following

Thickness of a pencil.


When a screw gauge with a least count of 0.01 mm is used to measure the diameter of a wire, the reading on the sleeve is found to be 1 mm and the reading on the thimble is found to be 27 divisions.

(i) What is the diameter of the wire in cm?

(ii) If the zero error is +0.005 cm, what is the correct diameter?


(a) A vernier scale has 10 divisions. It slides over the main scale, whose pitch is 1.0 mm. If the number of divisions on the left hand of zero of the vernier scale on the main scale is 56 and the 8th vernier scale division coincides with the main scale, calculate the length in centimetres.
(b) If the above instrument has a negative error of 0.07 cm, calculate the corrected length.


A micrometre screw gauge has a negative zero error of 8 divisions. While measuring the diameter of a wire the reading on the main scale is 3 divisions and the 24th circular scale division coincides with baseline.
If the number of divisions on the main scale are 20 to a centimetre and circular scale has 50 divisions, calculate

  1. pitch
  2. observed diameter.
  3. least count
  4. corrected diameter.

Find the volume of a book of length 25 cm, breadth 18 cm and height 2 cm in m3.


The level of water in a measuring cylinder is 12.5 ml. When a stone is lowered in it, the volume is 21.0 ml. Find the volume of the stone.


What do you mean by a negative zero error of a screw gauge? How will you calculate it?

Consider the following case where the zero of vernier scale and the zero of the main scale are clearly seen. If L.C. of the vernier calipers is 0.01 cm, write the zero error and zero correction of the following.


A screw gauge has 50 divisions on its circular scale and the pitch of the screw is 0.5 mm. What us its least count?

A vernier caliper using the scale invented by Galileo.


Advertisements
Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×