Advertisements
Advertisements
प्रश्न
An electric bulb is rated 220 V and 100 W. When it is operated on 110 V, the power consumed will be ______.
विकल्प
100 W
75 W
50 W
25 W
Advertisements
उत्तर
An electric bulb is rated 220 V and 100 W. When it is operated on 110 V, the power consumed will be 25 W.
Explanation:
Resistance of the bulb
∴ P = `"V"^2/"R"`
R = `"V"^2/"P"`
= `(220 "V"^2)/100`
= 484 Ω
Then, Power consumed at 110 V
P' = `("V'")^2/"R"`
= `(110 "V"^2)/484`
= 25 W
APPEARS IN
संबंधित प्रश्न
An electric heater is rated at 2 kW. Electrical energy costs Rs 4 per kWh. What is the cost of using the heater for 3 hours?
(a) Rs 12
(b) Rs 24
(c) Rs 36
(d) Rs 48
Name two gases which are filled in filament type electric light bulbs.
1Kwh =`( 1 "volt "xx 1 am pere xx.............)/1000`
Calculate the current through a 60 W lamp rated for 250 V. If the line voltage falls to 200 V, how is the power consumed by the bulb affected?
A bulb marked 12 V, 24 W operated on a 12 volt battery for 20 minutes. Calculate:
(i) the current flowing through it, and
(ii) the energy consumed
Two resistors A and B of resistance 4 Ω and 6 Ω respectively are connected in parallel. The combination is connected across a 6 volt battery of negligible resistance. Calculate: (i) the power supplied by the battery, (ii) the power dissipated in each resistor.
The diagram above shows a circuit with the key k open. Calculate :
(i) the resistance of the circuit when the key k is open.
(ii) the current drawn from the cell when the key k is open.
(iii) the resistance of the circuit when the key k is closed.
(iv) the current drawn from the cell when the key k is closed.
The diagram below shows a magnetic kept just below the conductor AB which is kept in North South direction.
(i) In which direction will the needle deflect when the key is closed ?
(ii) Why is the deflection produced ?
(iii) What will be the change in the deflection if the magnetic needle is taken just above the conductor AB ?
(iv) Name one device which works on this principle.
Household wiring for lamp connections can either be done in parallel or in series.Which one would you prefer? Give a reason for your answer.
How does the heat produced by die passage of current in a metallic wire depend on the time of passage of current in the wire?
State relative advantages and disadvantages of ring system of wiring over the tree system.
At what voltage is the electric power generated at the generating station? Explain the transmission of this power to your house.
How is the amount of heat produced calculated due to the passage of current in a metallic conductor? Derive an expression for it.
State other bigger units of electric power and express them in watt.
An electric kettle is rated 3kW, 250V. What should be the current capacity of the fuse with it?
The electrical power and current in the circuit relates by ______
Using a long extension cord in which each conductor has a resistance of 8Ω, a bulb marked as '100 W, 200 V' is connected to a 220 V dc supply of negligible internal resistance as shown in the figure. The power delivered to the bulb is ______ W.
A conductor of 10 Ω is connected across a 6 V ideal source. The power supplied by the source to the conductor is ______.
