हिंदी

Household Wiring for Lamp Connections Can Either Be Done in Parallel Or in Series.Which One Would You Prefer? Give a Reason for Your Answer. - Physics

Advertisements
Advertisements

प्रश्न

Household wiring for lamp connections can either be done in parallel or in series.Which one would you prefer? Give a reason for your answer.

टिप्पणी लिखिए
Advertisements

उत्तर

We would prefer the parallel wiring. This is done for the following reasons:
(i) In parallel wiring, each lamp can have its independent switch and the disconnection (putting off) of one of them will not effect the other lamps.
(ii) All lamps have the same potential difference (equal to that of the mains) across the terminals and are thus able to work as per their specified rating.

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?

संबंधित प्रश्न

What is the SI unit of (i) electric energy, and (ii) electric power?


In a house two 60 W electric bulbs are lighted for 4 hours, and three 100 W bulbs for 5 hours everyday. Calculate the electric consumed in 30 days.


A geyser is rated 1500 W, 250 V. This geyer is connected to 250 V mains. Calculate:
(i) the current drawn
(ii) the energy consumed in 50 hours, and
(iii) the cost of energy consumed at Rs. 4.20 per kWh


A simple electric circuit has a 30 V battery and a resistor ot 60 o. What will be the current in the circuit? The resistance of the oonnecting wires is negligible.


Name the physical quantity which is measured in kW.


What are the two main systems of wiring commonly used in houses? Which of these systems mentioned by you is better and why?


A house is provided with 15 bulbs of 40W, 5 bulbs of 100W, 5 fans of 80 W, and one heater of 1.0 kW. Each day bulbs are used for 4h, fans for lOh, and heater for 2h. The voltage of mains is 220 V. Calculate:
(i) Maximum power of the circuit in the house,
(ii) maximum current capacity of the main fuse in the house,
(iii) the electrical energy consumed in a week,
(iv) cost of electricity consumed at 1.25 Rs. per kWh.


Two bulbs are rated: bulb A 100W, 120 V bulb B 10 W, 120 V. If both are connected across a 120V supply, which bulb will consume more energy, When in parallel? Also calculate the current through each bulb in the above cases.


A consumer uses 4 lamps of 60 watt, 2 lamps of 40 watt, and 2 lamps of 100 watt. All these are used for 6 hour daily. Find the total bill for 30 days when the rate of energy is 75 paise per unit and the meter rent is Rs. 1.


Compare the power used in the 2 Ω resistor in each of the following circuits:

  1. a 6 V battery in series with 1 Ω and 2 Ω resistors
  2. a 4 V battery in parallel with 12 Ω and 2 Ω resistors.

Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×