Advertisements
Advertisements
प्रश्न
Household wiring for lamp connections can either be done in parallel or in series.Which one would you prefer? Give a reason for your answer.
Advertisements
उत्तर
We would prefer the parallel wiring. This is done for the following reasons:
(i) In parallel wiring, each lamp can have its independent switch and the disconnection (putting off) of one of them will not effect the other lamps.
(ii) All lamps have the same potential difference (equal to that of the mains) across the terminals and are thus able to work as per their specified rating.
संबंधित प्रश्न
Write the formula for electric power in terms of potential difference and current.
State the S.I. unit of electrical power.
Two resistors A and B of 4 Ω and 6 Ω, respectively are connected in parallel. The combination is connected across a 6 volt battery of negligible resistance. Calculate the power dissipated in each resistor.
Water in an electric kettle connected to a 220 V supply took 5 minutes to reach its boiling point. How long will it take if the supply voltage falls to 200 V?
Define electric power. An electrical device of resistance R is connected across a source of voltage V and draws a current I. Derive an expression for power in terms of current and resistance.
You are required to connect a bulb, a fan and a socket outlet to the mains in one set A and an air-conditioner and a refrigerator to the mains in other set B. Will you recommend the wire of same thickness and same insulation in both? explain your answer.
An electric bulb is rated 240V-60W and is working at 100% efficiency.
(i) Calculate the resistance of bulb.
(ii) (a) Draw the circuit diagram.
(b) What is the rate of conversion of energy in each bulb?
(c) Total power used by the bulbs.
With reference to the diagram shown below calculate:
(i) The equivalent resistance between P and Q.
(ii) The reading of ammeter.
(iii) The electrical power between P and Q.
Find the energy released by a current of 0.25 amperes flowing through a heater for 5 minutes. The p.d. is 230 V.
The resistance of filament of an electric heater is 500 Ω It is operated at 200V for 1 hour daily. Calculate the current drawn by the heater and the energy consumed in joule.
