Advertisements
Advertisements
प्रश्न
Advertisements
उत्तर
Four components of an electrical circuit
(i) Cell 
(ii) A load (bulb) 
(iii) Key 
(iv) Connecting wire 
APPEARS IN
संबंधित प्रश्न
An electric lamp is labelled 12 V, 36 W. This indicates that it should be used with a 12 V supply. What other information does the label provide?
State and define the household unit of electricity.
A geyser is rated 1500 W, 250 V. This geyer is connected to 250 V mains. Calculate:
(i) the current drawn
(ii) the energy consumed in 50 hours, and
(iii) the cost of energy consumed at Rs. 4.20 per kWh
A potential difference of 6 V is applied across a 3 Ω resistor. What is the current flowinq throuqh the circuit?
What would happen and why, to an electric bulb when it is connected across a supply of voltage (i) lower (ii) higher than its proper rating?
What is the order of current drawn by appliances connected to the ‘light circuit’ of a household?
State the reason why, in a three-pin plug, the earth pin is longer and thicker than the other two.
Three 250 W heaters are connected in parallel to a 100 V supply, Calculate total current taken from the supply.
A room has AC run for 5 hours a day at a voltage of 220V. The wiring of the room consists of Cu of 1 mm radius and a length of 10 m. Power consumption per day is 10 commercial units. What fraction of it goes in the joule heating in wires? What would happen if the wiring is made of aluminium of the same dimensions?
`[ρ_(Cu) = 1.7 xx 10_(Ωm)^-8, ρ_(Al) = 2.7 xx 10^-8 Ωm]`
Two heaters A and B have power rating of 1 kW and 2 kW, respectively. Those two are first connected in series and then in parallel to a fixed power source. The ratio of power outputs for these two cases is ______
