Advertisements
Advertisements
प्रश्न
In the block diagram of a simple modulator for obtaining an AM signal, shown in the figure, identify the boxes A and B. Write their function.
Advertisements
उत्तर
In the block diagram of modulator, A is Square Law Device and B is Band pass filter.
Band pass filter rejects low and high frequencies and allows a band of frequencies to pass through.
Square law device is a non linear device. It produces a non-linear output of message and carrier signals. The output from square law device is,
y(t)=Bx(t)+Cx2(t)
Where, B and C are constants and x(t)=message signal (Amsinωmt) + carrier signal (Acsinωct)
APPEARS IN
संबंधित प्रश्न
How are side bands produced?
The carrier wave is given by
C(t) = 2sin(8πt) volt.
The modulating signal is a square wave as shown. Find modulation index.
A carrier wave of peak voltage 12 V is used to transmit a message signal. What should be the peak voltage of the modulating signal in order to have a modulation index of 75%?
Due to economic reasons, only the upper sideband of an AM wave is transmitted, but at the receiving station, there is a facility for generating the carrier. Show that if a device is available which can multiply two signals, then it is possible to recover the modulating signal at the receiver station.
The carrier wave of a signal is given by C(t) = 3 sin (8πt) volt. The modulating signal is a square wave as shown. Find its modulation index.
Given modulation index physical significance .For an amplitude modulated wave, the maximum amplitude is found to be 10 V while the minimum amplitude is 2 V. Determine the modulation index μ ?
A 20 volt AC is applied to a circuit consisting of a resistance and a coil with negligible resistance. If the voltage across the resistance is 12 volt, the voltage across the coil is ______.
I-V characteristics of four devices are shown in Figures.
 |
 |
 |
|
| (i) | (ii) | (iii) | (iv) |
Identify devices that can be used for modulation.
A male voice after modulation-transmission sounds like that of a female to the receiver. The problem is due to ______.
An audio signal of 15kHz frequency cannot be transmitted over long distances without modulation because ______.
- the size of the required antenna would be at least 5 km which is not convenient.
- the audio signal can not be transmitted through sky waves.
- the size of the required antenna would be at least 20 km, which is not convenient.
- effective power transmitted would be very low, if the size of the antenna is less than 5 km.
