Advertisements
Advertisements
प्रश्न
What would be the danger involved in replacing a blown fuse with the one which would carry a large current?
Advertisements
उत्तर
Replacing a fuse with another fuse of higher rating wou Id al low a large current to flow through the circuit or applia nee to which the fuse is connected and thus, there is a chance of short-circuiting and the appliance may get damaged.
APPEARS IN
संबंधित प्रश्न
Three 2 V cells are connected in series and used as a battery in a circuit.
How many joules of electrical energy does 1 C gain on passing through (i) one cell (ii) all three cells?
In the circuit shown below, the voltmeter reads 10 V.
(a) What is the combined resistance?
(b) What current flows?
(c) What is the p.d. across 2 Ω resistor?
(d) What is the p.d. across 3 Ω resistor?
What happens to the other bulbs in a parallel circuit if one bulb blows off?
Consider the circuit given below:
(a) In which circuit are the lamps dimmest?
(b) In which circuit or circuits are the lamps of equal brightness to the lamps in circuit (i)?
(c) Which circuit gives out the maximum light?
A 720 W heater operates from a 220 V line voltage. Calculate:
(a) The electrical energy consumed by the heater in 3 h.
(b) The cost of electrical energy consumption at the rate of 60 paise per kWh.
An electric kettle has a heating element which is rated at 2 kW when connected to a 250 V electric supply. Calculate the
(a) Current which flows in the element when it is connected to a 250 V supply,
(b) Resistance of the filament,
(c) Heat produced in 1 minute by the element,
(d) Cost of running the kettle for 10 minutes a day for 30 days of the month, at the rate of Rs. 3.00 per unit.
The circuit diagram in fig shows two coils of an insulated copper wire wound on a cardboard tube. G is a center zero galvanometer.
(a) Describe what will happen when th e swi tch K is cl osed for severa l
seconds and then opened again .
(b) What will be the effect of repeating the experiment with an iron placed in the tube?
Three heaters each rated 250 W, 100 V are connected in parallel to a 100 V supply. The resistance of each heater
An ammeter is always placed in parallel with the circuit.
