हिंदी
तमिलनाडु बोर्ड ऑफ सेकेंडरी एज्युकेशनएसएसएलसी (अंग्रेजी माध्यम) कक्षा ७

Water : pipe :: Electric current : ______. - Science

Advertisements
Advertisements

प्रश्न

Water : pipe :: Electric current : ______.

रिक्त स्थान भरें
Advertisements

उत्तर

Water: pipe:: Electric current: wire

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
अध्याय 2: Electricity - Evaluation [पृष्ठ ३३]

APPEARS IN

सामाचीर कलवी Science - Term 2 [English] Class 7 TN Board
अध्याय 2 Electricity
Evaluation | Q V. 1. | पृष्ठ ३३

संबंधित प्रश्न

Fill in the folloing blank with suitable words:

 A current is a flow of ............... .For this to happen there must be a ............... circuit.


A flash of lighting carries 10 C of charge which flows for 0.01 s. What is the current? If the voltage is 10 MV, what is the energy?


An electric circuit consisting of a 0.5 m long nichrome wire XY, an ammeter, a voltmeter, four cells of 1.5 V each and a plug key was set up.

(i) Draw a diagram of this electric circuit to study the relation between the potential difference maintained between the points 'X' and 'Y' and the electric current flowing through XY.


(a) With the help of a circuit diagram, obtain the relation for the equivalent resistance of two resistances connected in parallel.
(b) In the circuit diagram shown below, find:

(i) Total resistance.
(ii) Current shown by the ammeter 


Give three reasons why different electrical appliances in a domestic circuit are connected in parallel.


Can a copper wire be used as a fuse wire?

The diagram shows two ways of connecting three lamps P, Q and R to A.C. supply of 220 V.

Name the two arrangements. Which of them would you prefer in a household circuit? Give a reason for your answer.

Tick (✓) the correct choice among the following :

Which of the following changes would enable a millimeter to be used as a
direct current ammeter reading upto 1 A?


An electric bulb is rated 250 W, 230 V. 

  1. the energy consumed in one hour, and
  2. the time in which the bulb will consume 1.0 kWh energy when connected to 230 V mains.

What should I choose ___________________

a. for decreasing resistance in a circuit.
(Resistors in series / Resistors in parallel)

b. for getting protection from electric current.
(Nickel / Ebonite)

c. to measure the current in the circuit?
(Ammeter/ Voltmeter) 

Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×