Advertisements
Advertisements
प्रश्न
Two similar vehicles are moving with the same velocity on the road, such that one of thus is loaded and the other one is empty which of the two vehicles will require larger force to stop?
Advertisements
उत्तर
A large force is required to stop the loaded vehicle. It is because the loaded vehicle has greater momentum than the empty vehicle as the mass of the loaded vehicle is more than that of the empty one. So, it requires more force to stop.
संबंधित प्रश्न
An effort is applied on the bigger wheel of a gear having 32 teeth. It is used to turn a wheel of 8 teeth. Where it is used.
A half metre rod is pivoted at the centre with two weights of 20gf and 12gf suspended at a perpendicular distance of 6 cm and 10 cm from the pivot respectively as shown below.
1) Which of the two forces acting on the rigid rod causes clockwise moment?
2) Is the rod in equilibrium?
3) The direction of 20 kgf force is reversed. What is the magnitude of the resultant moment of the forces on the rod?
Moment of force = force × perpendicular distance of force – from the pivoted point.
Thrust is the ............ force acting on a surface.
SI. unit of moment of force is
State the effect of force F in of the following diagram.
The diagram shows two forces F1 = 5 N and F2 = 3N acting at point A and B of a rod pivoted at a point O, such that OA = 2m and OB = 4m
Calculate:
- Moment of force F1 about O
- Moment of force F2 about O
- Total moment of the two forces about O.
The diagram in the figure shows a uniform metre rule weighing 100 gf, pivoted as its centre O. two weight 150 gf and 250 gf hang from the point A and B respectively of the metre rule such that OA = 40 cm and OB = 20 cm . Calculate
the total anticlockwise moment about o.
Fig. shows a uniform meter scale weighing 100 N pivoted at its centre. Two weights of 500 N and 300 N are hung from the ruler as shown in fig.
(i) Calculate total clockwise and anticlockwise moments.
(ii) Calculate difference in clockwise moment and anticlockwise moment.
(iii) Calculate the distance from O where a 100 N weight should be suspended to balance the meter scale.
A door lock is opened by turning the lever (handle) of length 0.2 m. If the moment of force produced is 1 Nm, then the minimum force required is ______.
