हिंदी

Show that the Current Leads the Voltage in Phase By π/2 in an Ac Circuit Containing an Ideal Capacitor ? - Physics

Advertisements
Advertisements

प्रश्न

Show that the current leads the voltage in phase by π/2 in an AC circuit containing an ideal capacitor ?

Advertisements

उत्तर

Let us consider a capacitor C connected to an AC source as shown below.

 Let the AC voltage applied be

`v = v_msinωt`

`∴ v = q/C`

Applying Kirchhoff’s loop rule, we have:

` v_msinωt  q/C`

`i = (dq)/dt`

`∴ i = (d)/dt( v_mCsinωt) `

`ωCv_mcos(ωt)`

`cos ωt = sinωt+π/2`

`∴ i = i_msin(ωt+π/2)`

`i_m = ωCv_m`

`i =(v_m)/((1/(ωC)))`

Hence, the current leads the voltage in phase by π/2.
shaalaa.com
Different Types of AC Circuits: AC Voltage Applied to a Capacitor
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
2013-2014 (March) Foreign Set 3

संबंधित प्रश्न

A capacitor acts as an infinite resistance for ______.


An AC source producing emf ε = ε0 [cos (100 π s−1)t + cos (500 π s−1)t] is connected in series with a capacitor and a resistor. The steady-state current in the circuit is found to be i1 cos [(100 π s−1)t + φ1) + i2 cos [(500π s−1)t + ϕ2]. So,


A bulb rated 60 W at 220 V is connected across a household supply of alternating voltage of 220 V. Calculate the maximum instantaneous current through the filament.


The dielectric strength of air is 3.0 × 106 V/m. A parallel-plate air-capacitor has area 20 cm2 and plate separation 0.10 mm. Find the maximum rms voltage of an AC source that can be safely connected to this capacitor.


Average power supplied to a capacitor over one complete cycle is ______.


When an ac voltage of 220 V is applied to the capacitor C, then ______.


Of the following about capacitive reactance which is correct?

An alternating current of 1.5 mA and angular frequency 300 rad/sec flows through a 10 k Ω resistor and a 0.50 µF capacitor in series. Find the rms voltage across the capacitor and impedance of the circuit.


In the LCR circuit shown in figure, the ac driving voltage is v = vm sin ωt.

  1. Write down the equation of motion for q (t).
  2. At t = t0, the voltage source stops and R is short circuited. Now write down how much energy is stored in each of L and C.
  3. Describe subsequent motion of charges.


An a.c. source generating a voltage ε = ε0 sin ωt is connected to a capacitor of capacitance C. Find the expression for the current I flowing through it. Plot a graph of ε and I versus ωt to show that the current is ahead of the voltage by π/2.


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×