Advertisements
Advertisements
प्रश्न
Two students ‘X’ and ‘Y’ perform an experiment on potentiometer separately using the circuit given below:

Keeping other parameters unchanged, how will the position of the null point be affected if
(i) ‘X’ increases the value of resistance R in the set-up by keeping the key K1 closed and the Key K2 opens?
(ii) ‘Y’ decreases the value of resistance S in the set-up, while the key K2 remains open and they K1 closed?
Justify.
Advertisements
उत्तर
(i) K1→ closed, K2→ Open

Suppose null point occurs at l,
Apply KVL in smaller loop,
ξ − l∅ = 0 …..(1)
Where, ∅ = potential drop per unit length in potentiometer wire
ξ = l∅
`=> l =xi/phi`
As X increase the value of resistance R, So, current in the circuit (wire) decrease. Hence, ∅ will be increases. Then l will decrease.
We can say, as X increases the value of R, null point decrease.
(ii) K2 → open, K1 → closed.
Then the circuit will be same as shown earlier.
We see that resistance S is not involved in the circuit because K2 is open.
So, from equation (1)
ξ = ∅l
`=> l=xi/phi`
Here, ∅ does not depends on the value of resistance S.
So, ∅ null point is not affected by decreasing the value of resistance S.
संबंधित प्रश्न
Accuracy of potentiometer can be easily increased by ______.
On what factors does the potential gradient of the wire depend?
In a potentiometer experiment, balancing length is found to be 120 cm for a cell E1 of emf 2V. What will be the balancing length for another cell E2 of emf 1.5V? (No other changes are made in the experiment.)
How is potential gradient measured? Explain.
A potentiometer wire has a length of 1.5 m and a resistance of 10 Ω. It is connected in series with the cell of emf 4 Volt and internal resistance 5 Ω. Calculate the potential drop per centimeter of the wire.
A potentiometer wire of Length 10 m is connected in series with a battery. The e.m.f. of a cell balances against 250 cm Length of wire. If length of potentiometer wire is increased by 1 m, the new balancing length of wire will be ____________.
If the length of potentiometer wire is increased, then the length of the previously obtained balance point will ______.
What is the value of resistance for an ideal voltmeter?
Draw neat labelled diagram of potentiometer as voltage divider.
