Advertisements
Advertisements
प्रश्न
Draw the output signals C1 and C2 in the given combination of gates (Figure).
Advertisements
उत्तर
`C_1 = barbar(barA * barB) = barbar(barbarA + barbarB) = bar(A + B)`
| A | B | C | D | E | F | G | H | I | C1 |
| 0 | 0 | 0 | 0 | 1 | 1 | 1 | 0 | 0 | 1 |
| 1 | 0 | 1 | 0 | 0 | 1 | 0 | 1 | 1 | 0 |
| 0 | 1 | 0 | 1 | 1 | 0 | 0 | 1 | 1 | 0 |
| 1 | 1 | 1 | 1 | 0 | 0 | 0 | 1 | 1 | 0 |
`C_2 = bar(barA * barB) = barbarA + barbarB = A * B`
| A | B | C | D | E | F | G | C2 |
| 0 | 0 | 0 | 0 | 1 | 1 | 1 | 0 |
| 1 | 0 | 1 | 0 | 0 | 1 | 1 | 0 |
| 0 | 1 | 0 | 1 | 1 | 0 | 1 | 0 |
| 1 | 1 | 1 | 1 | 0 | 0 | 0 | 1 |
APPEARS IN
संबंधित प्रश्न
The following figure shows the input waveforms (A, B) and the output waveform (Y) of a gate. Identify the gate, write its truth table and draw its logic symbol.
You are given the two circuits as shown in following figure. Show that circuit
- acts as OR gate while the circuit
- acts as AND gate.
(a)
(b)
You are given two circuits as shown in following figure, which consist of NAND gates. Identify the logic operation carried out by the two circuits.
(a)
(b)
Write the truth table for circuit given in figure below consisting of NOR gates and identify the logic operation (OR, AND, NOT) which this circuit is performing.
(Hint: A = 0, B = 1 then A and B inputs of second NOR gate will be 0 and hence Y=1. Similarly work out the values of Y for other combinations of A and B. Compare with the truth table of OR, AND, NOT gates and find the correct one.)
Draw the schematic symbols for AND, OR, NOT and NAND gate
Draw logic symbol of an OR gate and write its truth table.
Answer the following question :
Distinguish between digital and analogue signals.
Let \[X = A \overline{ BC} + B\overline{ CA} + C\overline{AB } .\] Evaluate X for A = 1, B = 0, C = 1.
Let \[X = A \overline{ BC} + B\overline{ CA} + C\overline{AB } .\] Evaluate X for A = B = C = 1.
Let \[X = A \overline{ BC} + B\overline{ CA} + C\overline{AB } .\] Evaluate X for A = B = C = 0.
Show that \[AB + \overline {AB }\] is always 1.
The amplification factor of a triode operating in the linear region depends strongly on ____________ .
The current obtained from a simple filterless rectifier is
The Boolean expression for NAND gate is
In potential barrier development in a junction diode opposes
For the given circuit, the input digital signals are applied at terminals A, B, and C. What would be the output at terminal y?
Truth table for the given circuit (Figure) is ______.
In the logic circuit shown in the figure, if input A and B are 0 to 1 respectively, the output at Y would be 'x'. The value of x is ______.
Which of the following gives a reversible operation?
