Advertisements
Advertisements
प्रश्न
If p0 = 1.03 × 105 Nm–2, ρ0 = 1.29 kg m–3 and g = 9.8 ms–2, at what height will the pressure drop to (1/10) the value at the surface of the earth?
Advertisements
उत्तर
As p = `p_0e^((ρ_0gh)/p_0)`,
⇒ In `p/p_0 = - (ρ_0gh)/p_0`
By question, `p = 1/10 p_0`
⇒ In `((1/10 p_0)/p_0) = - (ρ_0g)/p_0 h`
⇒ In `1/10 = - (ρ_0g)/p_0 hρ_0`
∴ h = `- p_0/(ρ_0g)` In `1/10` `- p_0/(p_0g)` In `(10)^-1`
= `p_0/(ρ_0g)` In 10`
= `p_0/(ρ_0g) xx 2.303` .....[∵ In (x) = 2.303 log10(x)]
= `(1.013 xx 10^5)/(1.22 xx 9.8) xx 2.303`
= 0.16 × 105 m
= 16 × 103 m
APPEARS IN
संबंधित प्रश्न
Fill in the blanks using the word(s) from the list appended with each statement
For the model of a plane in a wind tunnel, turbulence occurs at a ... speed for turbulence for an actual plane (greater / smaller)
Explain why To keep a piece of paper horizontal, you should blow over, not under, it
Explain why A spinning cricket ball in air does not follow a parabolic trajectory
Can Bernoulli’s equation be used to describe the flow of water through a rapid in a river? Explain.
In a test experiment on a model aeroplane in a wind tunnel, the flow speeds on the upper and lower surfaces of the wing are 70 m s–1and 63 m s–1 respectively. What is the lift on the wing if its area is 2.5 m2? Take the density of air to be 1.3 kg m–3.
The cylindrical tube of a spray pump has a cross-section of 8.0 cm2 one end of which has 40 fine holes each of diameter 1.0 mm. If the liquid flow inside the tube is 1.5 m min–1, what is the speed of ejection of the liquid through the holes?
In deriving Bernoulli’s equation, we equated the work done on the fluid in the tube to its change in the potential and kinetic energy. (a) What is the largest average velocity of blood flow in an artery of diameter 2 × 10–3 m if the flow must remain laminar? (b) Do the dissipative forces become more important as the fluid velocity increases? Discuss qualitatively.
Water is flowing through a long horizontal tube. Let PA and PB be the pressures at two points A and B of the tube.
Suppose the tube in the previous problem is kept vertical with A upward but the other conditions remain the same. the separation between the cross sections at A and B is 15/16 cm. Repeat parts (a), (b) and (c) of the previous problem. Take g = 10 m/s2.
Suppose the tube in the previous problem is kept vertical with B upward. Water enters through B at the rate of 1 cm3/s. Repeat parts (a), (b) and (c). Note that the speed decreases as the water falls down.
What is the basis of Bernoulli’s principle?
A large number of liquid drops each of radius 'a' are merged to form a single spherical drop of radius 'b'. The energy released in the process is converted into kinetic energy of the big drop formed. The speed of the big drop is [p = density of liquid, T = surface tension of liquid] ____________.
When one end of the capillary is dipped in water, the height of water column is 'h'. The upward force of 119 dyne due to surface tension is balanced by the force due to the weight of water column. The inner circumference of the capillary is (Surface tension of water= 7 x 10-2 N/m) ____________.
Which of the following is NOT an example of the application of Bernoulli's principle?
Dynamic lift caused by spinning is called ______.
In the widest part of the horizontal pipe, oil is flowing at a rate of 2 m/sec. The speed (in m/s) of the flow of oil in the narrow part of the tube if the pressure difference in the broad and narrow parts of the pipe is 0.25 ρoilg, is ______ m/s.
Calculate the velocity with which the liquid gushes out of the 4 cm2 outlet, if the liquid flowing in the tube is water and the liquid in the U tube has a specificity 12. The velocity of the liquid at point A is `sqrt20.2` m/s ______.
Explain the working of an atomizer.
