Advertisements
Advertisements
प्रश्न
How is a transistor biased to be in active state?
Advertisements
उत्तर
There are two conditions for a transistor to be into an active region.
1. The input circuit should be forward biased by using a low voltage battery.
2. The output circuit should be reverse biased by using a high voltage battery.
APPEARS IN
संबंधित प्रश्न
What are α and β parameters for a transistor? Obtain a relation between them.
Write clearly, why in the case of a transistor (i) the base is thin and lightly doped
Write clearly, why in the case of a transistor (ii) the emitter is heavily doped.
Differentiate between three segments of a transistor on the basis of their size and level of doping.
When a p-n-p transistor is operated in saturation region, then its ______.
(A) base-emitter junction is forward biased and base-collector junction is reverse biased.
(B) both base-emitter and base-collector junctions are reverse biased.
(C) both base-emitter and base-collector junctions are forward biased.
(D) base-emitter junction is reverse biased and base-collector junction is forward biased
Write the functions of the three segments of a transistor.
The figure shows the input waveforms A and B for ‘AND’ gate. Draw the output waveform and write the truth table for this logic gate.
Draw a typical input and output characteristics of an n-p-n transistor in CE configuration. Show how these characteristics can be used to determine (a) the input resistance (r1), and (b) current amplification factor (β)
Draw typical output characteristics of an n-p-n transistor in CE configuration. Show how these characteristics can be used to determine output resistance.
If an emitter current is changed by 4 mA, the collector current changes by 3.5 mA. The value of β will be ______.
