Advertisements
Advertisements
प्रश्न
How is the magnetic field due to a solenoid carrying current affected if a soft iron bar is introduced inside the solenoid?
Advertisements
उत्तर
Magnetic field due to a solenoid carrying current increases if a soft iron bar is introduced inside the solenoid.
APPEARS IN
संबंधित प्रश्न
State the direction in which current-carrying freely suspended solenoid rests
The adjacent diagram shows a small magnet placed near a solenoid AB. Current is switched on in the solenoid by pressing the key K.
- State the polarity at the ends A and B.
- Will the magnet be attracted or repelled? Give a reason for your answer.
A current carrying solenoid behaves like a ______.
A current carrying solenoid when freely suspended, it always rests in ______ direction.
- What name is given to a cylindrical coil of diameter less than its length?
- If a piece of soft iron is placed inside the coil mentioned in part (a) and current is passed in the coil from a battery, what name is then given to the device so obtained?
- Give one use of the device mentioned in part (b).
Draw the pattern of magnetic field lines of a solenoid through which a steady current flows. What does the pattern of field lines inside the solenoid indicate?
The diagram shows a current-carrying coil passing through a cardboard sheet. Draw three magnetic lines of force on the board.
State two factors on which magnitude of magnetic field at the centre depends.
The diagram below shows a magnet moved near a coil along its axis. Which of the diagram shows correct flow of current during this motion?
The diagram below shows an insulated copper wire wound around a hollow cardboard cylindrical tube. Answer the questions that follow:
- What are the magnetic poles at A and B when the key K is closed?
- State two ways to increase the strength of the magnetic field in this coil without changing the coil.
- If we place a soft iron bar at the centre of the hollow cardboard and replace the DC source with an AC source then will it attract small iron pins toward itself when the current is flowing through the coil?
How is a solenoid prepared?
