Advertisements
Advertisements
प्रश्न
Why is heating coil wound in the form of a helix in electric stove?
Advertisements
उत्तर
This reduces the area over which element of heater is spread. As heat is produced over smaller area, therefore temperature of its element rises to about 1000°C.
संबंधित प्रश्न
Which of the following terms does not represent electrical power in a circuit?
How much energy does a 100 W electric bulb transfer in 1 minute?
(a) 100 J
(b) 600 J
(c) 3600 J
(d) 6000 J
At a given time, a house is supplied with 100 A at 220 V. How many 75 W, 220 V light bulb could be switched on in the house at the same time (if they are all connected in parallel)?
Name the S.I unit of electrical energy. How is it related to Wh?
An immersion heater rated 1000 W, 220 V is used to heat 0.01 m3 of water. Assuming that the power is supplied at 220 V and 60% of the power supplied is used to heat the water, how long will it take to increase the temperature of the water from 15°C to 40°C?
The coil of an electric bulb takes 40 watts to start glowing. If more than 40 W are supplied, 60% of the extra power is converted into light and the remaining into heat. The bulb consumes 100 W at 220 V. Find the percentage drop in the light intensity at a point if the supply voltage changes from 220 V to 200 V.
The diagram shows a coil connected to a center zero galvanometerG . The galvanometer shows a deflect ion to the right when the north pole N of a powerful magnet is moved to the right as shown .
(i) Explain, why the defelct ion occurs in the galvanometer.
(ii ) State whether th e current in the coil is cl ockwise or anticl ockwise
when viewed from the end P.
(iii ) State th e observation in G when the coil is moved away from north
pole N of the magnet keeping the magnet stationary.
(iv)State the observation in G when both the coil and the magnet are
moved to right at th e same speed .
What is the meaning of electric power of an electrical device? Write its SI unit.
Using a long extension cord in which each conductor has a resistance of 8Ω, a bulb marked as '100 W, 200 V' is connected to a 220 V dc supply of negligible internal resistance as shown in the figure. The power delivered to the bulb is ______ W.
