Advertisements
Advertisements
प्रश्न
What is (a) the highest, (b) the lowest total resistance that can be secured by combinations of four coils of resistance 4 Ω, 8 Ω, 12 Ω, 24 Ω?
Advertisements
उत्तर
There are four coils of resistances: 4 Ω, 8 Ω, 12 Ω and 24 Ω, respectively.
(a) If these coils are connected in series, then the equivalent resistance will be the highest, given by the sum 4 + 8 + 12 + 24 = 48 Ω
(b) If these coils are connected in parallel, then the equivalent resistance will be the lowest, given by,
`1/(1/4+1/8+1/12+1/24)=1/((6+3+2+1)/24)=24/12=2 Omega`
Therefore, 2 Ω is the lowest total resistance.
APPEARS IN
संबंधित प्रश्न
On what factors does the resistance of a conductor depend?
Use the data in the Table given below to answer the following –
Which among iron and mercury is a better conductor?
Table give below Electrical resistivity of some substances at 20°C
| Electrical resistivity of some substances at 20°C | ||
| − | Material | Resistivity (Ω m) |
| Conductors |
Silver | 1.60 × 10−8 |
| Copper | 1.62 × 10−8 | |
| Aluminium | 2.63 × 10−8 | |
| Tungsten | 5.20 × 10−8 | |
| Nickel | 6.84 × 10−8 | |
| Iron | 10.0 × 10−8 | |
| Chromium | 12.9 × 10−8 | |
| Mercury | 94.0 × 10−8 | |
| Manganese | 1.84 × 10−6 | |
| Alloys |
Constantan (alloy of Cu and Ni) |
49 × 10−6 |
| Manganin (alloy of Cu, Mn and Ni) |
44 × 10−6 | |
| Nichrome (alloy of Ni, Cr, Mn and Fe) |
100 × 10−6 | |
| Insulators | Glass | 1010 − 1014 |
| Hard rubber | 1013 − 1016 | |
| Ebonite | 1015 − 1017 | |
| Diamond | 1012 − 1013 | |
| Paper (dry) | 1012 | |
Why are copper and aluminium wires usually employed for electricity transmission?
List the factors on which the resistance of a conductor in the shape of a wire depends.
Distinguish between good conductors, resistors and insulators. Name two good conductors, two resistance and two insulators.
What happens to the resistance as the conductor is made thicker?
Which has more resistance:
a thick piece of nichrome wire or a thin piece?
What do you understand by the "resistivity" of a substance?
Give two examples of substances which are good conductors of electricity. Why do you think they are good conductors of electricity?
What would be the effect on the resistance of a metal wire of:
increasing its length?
What would be the effect on the resistance of a metal wire of:
increasing its diameter?
How does the resistance of a wire change when:
its material is changed to one whose resistivity is three times?
Calculate the area of cross-section of a wire if its length is 1.0 m, its resistance is 23 Ω and the resistivity of the material of the wire is 1.84 × 10−6 Ω m.
The figure blow shows a variable resistor in a dimmer switch.
How would you turn the switch to make the lights: (a) brighter, and (b) dimmer? Explain your answer.
Write the relation between resistance and electrical resistivity of the material of a conductor in the shape of a cylinder of length `'l'` and area of cross-section `'A'` . Hence derive the S.I. unit of electrical resistivity.
How will you infer with the help of an experiment that the same current flows through every part of the circuit containing three resistors R1, R2 and R3 in series connected to a battery of V volts?
The element used almost exclusively for filaments of incandescent lamps:
The effective resistance between A and B is:
