Advertisements
Advertisements
प्रश्न
The primary coil of a transformer has 60 turns whereas its secondary coil has 3000 turns.
If a 220 V ac voltage is applied to the primary coil, how much emf is induced in the secondary coil?
Advertisements
उत्तर
The voltage of primary coils is
VP = 220 V
Let the voltage of secondary coil be VS.
Now `"N"_"s"/"N"_"P" = "V"_"S"/"V"_"P"`
⇒ `3000/60 = "V"_"S"/220`
⇒ VS = 50 × 220
= 11,000 volt
VS = 11,000 V
APPEARS IN
संबंधित प्रश्न
Derive an expression for ratio of e.m.f.s and currents in terms of number of turns in primary and secondary coil.
State two factors on which the magnitude of induced e.m.f. depend.
Explain why an induced current must flow in such a direction so as to oppose the change producing it.
The following diagram in Fig. 10.44 shows a coil X connected to a sensitive centre –zero galvanometer G and a coil P connected to a battery through a switch S.
(a) Describe the observation when the switch S is (i) closed suddenly, (ii) then kept closed, (iii) finally opened.
(b) Name and state the law which explains the above observations.
A transformer is designed to work from a 240 V a.c. mains and to give a supply of 8 V to ring a house bell. The primary coil has 4800 turns. How many turns will be in the secondary coil?
A transformer is essentially an a.c. device. It cannot work on d.c. It changes alternating voltages or currents. It does not affect the frequency of a.c. It is based on the phenomenon of mutual induction. A transformer essentially consists of two coils of insulated copper wire having different numbers of turns and wound on the same soft iron core.
The number of turns in the primary and secondary coils of an ideal transformer is 2000 and 50 respectively. The primary coil is connected to a main supply of 120 V and secondary coil is connected to a bulb of resistance 0.6 Ω.
The value of current in the bulb is ______.
Draw the effective equivalent circuit of the circuit shown in figure, at very high frequencies and find the effective impedance.
1 MW power is to be delivered from a power station to a town 10 km away. One uses a pair of Cu wires of radius 0.5 cm for this purpose. Calculate the fraction of ohmic losses to power transmitted if
- power is transmitted at 220 V. Comment on the feasibility of doing this.
- a step-up transformer is used to boost the voltage to 11000 V, power transmitted, then a step-down transfomer is used to bring voltage to 220 V. (ρCu = 1.7 × 10–8 SI unit)
What are the three main components of a transformer?
