मराठी
महाराष्ट्र राज्य शिक्षण मंडळएचएससी विज्ञान (सामान्य) इयत्ता १२ वी

In an AC circuit, e and i are given by e = 150 sin(150t)V and i = 150 sin π(150t+π3) A. The power dissipated in the circuit is ______.

Advertisements
Advertisements

प्रश्न

In an AC circuit, e and i are given by e = 150 sin(150t)V and i = 150 sin `(150t + π/3)` A. The power dissipated in the circuit is ______.

पर्याय

  • 106W

  • 150W

  • 5625W

  • Zero

MCQ
रिकाम्या जागा भरा
Advertisements

उत्तर

In an AC circuit, e and i are given by e = 150 sin(150t)V and i = 150 sin `(150t + π/3)` A. The power dissipated in the circuit is 5625W.

Explanation:

Let, Voltage supplied  = V = `150 sin(150t)` .....(1)

Current flowing = I = `150 sin(150t + pi/3)`  .....(2)

∵ `V = V_0 sin(wt)`

So, on comparing it with (1), we get

`V_0 = 150V`  .....(3)

Also,

∵ `I = I_0 sin(wt + phi)`

So, on comparing it with (2), we get

`I_0 = 150A`  ....(4)

`phi = pi/3`  .....(5)

As, the power in the AC circuit is given by:

`P = 1/2V_0I_0 cos phi`  ....(6)

Put the values in equations (3), (4), (5) and (6) and calculate:

∴ `P = 1/2 xx 150 xx 150 xx cos 60`

P = 5625W

shaalaa.com
  या प्रश्नात किंवा उत्तरात काही त्रुटी आहे का?
पाठ 13: AC Circuits - Exercises [पृष्ठ ३०४]

APPEARS IN

बालभारती Physics [English] Standard 12 Maharashtra State Board
पाठ 13 AC Circuits
Exercises | Q 1.4 | पृष्ठ ३०४

संबंधित प्रश्‍न

In a circuit L, C and R are connected in series with an alternating voltage of frequency f. the current leads the voltage by 45°. The value of C is ______.


An electric lamp is connected in series with a capacitor and an AC source is glowing with a certain brightness. How does the brightness of the lamp change on increasing the capacitance?


An electric current in an LC – circuit at resonance is called - ______ 


If AC voltage is applied to a pure capacitor, then the voltage across the capacitor ______  


A coil of resistance 300Ω and inductance 1.0 H is connected across an alternating voltage of frequency `300/(2pi)` Hz, therefore phase difference between the voltage and current in the circuit is ______ 


State the equation for impedance Z in an A.C. circuit.


If the peak value of an alternating emf is 15V, what is its mean value over half cycle?


A series LCR circuit has resistance 10Ω and reactance is `7sqrt2` Ω. What is the impedance of the circuit?


A 0.5µF capacitor is discharged through a 10 millihenry inductor. Find the frequency of discharge. 


What is the capacitive reactance of a capacitor of 5µF at a frequency of (1) 50 Hz and (2) 20KHZ? 


What is the inductive reactance of a coil of inductance 10mH at a frequency

  1.  50 Hz
  2. 1000 Hz
  3. 20 kHz?

Obtain the expression for the applied emf and the effective resistance of the circuit when alternating emf is applied to an LR circuit.


Obtain the expression for the applied emf and the effective resistance of the circuit when alternating emf is applied to a CR circuit.


For circuit shown in figure IE = 4 mA, IB = 40 µA. What are the values of ex, and le respectively?

   


In amplitude modulation. the amplitude of carrier wave is Ac and that of the modulating signal is Am· In practice, the ratio of Am to Ac is kept less than or equal to one, to avoid ______.


An RC Circuit as shown in the figure is driven by a AC source generating a square wave. The output wave pattern monitored by CRO would look close to:


A telegraph line of length 100 km has a capacity of 0.01 µF/ km and it carries an alternating current at 0.5 kilo cycle per second. If minimum impedance is required, then the value of the inductance that needs to be introduced in series is ______ mH. (if π = `sqrt10`)


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×