Advertisements
Advertisements
प्रश्न
If a bulb of 60W is connected across a source of 220V, find the current drawn by it.
Advertisements
उत्तर
Power P = 60W, Voltage V = 220. To find eye ?
We have current `I = P/V = 60/220= 0.272 A`
APPEARS IN
संबंधित प्रश्न
An electric bulb is rated 220 V and 100 W. When it is operated on 110 V, the power consumed will be ______.
What is the meaning of the symbol kWh? Which quantity does it represent?
Define watt. Write down an equation linking watts, volts and amperes.
The SI unit of energy is :
(a) joule
(b) coulomb
(c) watt
(d) ohm-metre
Name the physical quality which is measured in
(i) Kw (ii) kWh
An electric bulb marked 220 V, 100 W will get fused if it is made to consume 150 W or more. What voltage fluctuation will the bulb withstand?
Name two common material used for heating elements.
Why is heating element wound on a long porcelain rod in a room heater.
State the position of heating element with respect to principal focus of concave reflector and give reason for choosing this position.
Why is the heating element of an electric oven wound on a helix? State the reason.
An electric filament lamp is connected to a supply of voltage higher than the recommended value. Give reasons, why compared with a normal performance, the lamp emits a brighter light and its life is shortened.
Which material is the calorimeter commonly made of? Give one reason for using this material.
Two electric lamps each rating 100 W, 110 V are connected in series to a 220 V power supply and two other electric lamps each of marking 100 W, 220 V are connected in parallel to the same power supply. Will anyone of the two combinations give more light than the other? Give a reason for your answer.
Three 250 W heaters are connected in parallel to a 100 V supply, Calculate the resistance of each heater.
Out of the three fuses with current ratings 5A, 10A, 15A, which one is to be connected in a geyser circuit marked 3 kW, 220V? Give reason for your answer.
Two resistances R1 = 4Ω and R2 = 6Ω are connected in series. The combination is connected with a battery of e.m.f. 6V and negligible resistance. Calculate:
(i) the heat produced per minute in each resistor,
(ii) the power supplied by the battery.
Compare the power used in the 2 Ω resistor in each of the following circuits:
- a 6 V battery in series with 1 Ω and 2 Ω resistors
- a 4 V battery in parallel with 12 Ω and 2 Ω resistors.
A family uses 8 kW of power. Direct solar energy is incident on the horizontal surface at an average rate of 200 W per square meter. If 20% of this energy can be converted to useful electrical energy, how large an area is needed to supply 8 kW?
Two heaters A and B have power rating of 1 kW and 2 kW, respectively. Those two are first connected in series and then in parallel to a fixed power source. The ratio of power outputs for these two cases is ______
