Advertisements
Advertisements
प्रश्न
Copper of fixed volume V is drawn into a wire of length l. When this wire is subjected to a constant force F, the extension produced in the wire is ∆l. If Y represents Young’s modulus, then which of the following graphs is a straight line?
पर्याय
∆l versus V
∆l versus Y
∆l versus F
∆l versus `1/"l"`
Advertisements
उत्तर
∆l versus F
APPEARS IN
संबंधित प्रश्न
The load-elongation graph of three wires of the same material as shown in the figure. Which of the following wire is the thickest?
Two wires are made of the same material and have the same volume. The area of cross-sections of the first and the second wires are A and 2A respectively. If the length of the first wire is increased by ∆l on applying a force F, how much force is needed to stretch the second wire by the same amount?
The Young’s modulus for a perfect rigid body is __________.
If the temperature of the wire is increased, then Young’s modulus will __________.
The following four wires are made of the same material. Which of these will have the largest extension when the same tension is applied?
Which one of these is more elastic, steel or rubber? Why?
State Hooke’s law and verify it with the help of an experiment.
A cylinder of length 1.5 m and diameter 4 cm is fixed at one end. A tangential force of 4 × 105 N is applied at the other end. If the rigidity modulus of the cylinder is 6 × 1010 Nm-2 then, calculate the twist produced in the cylinder.
Why the passengers are advised to remove the ink from their pens while going up in an aeroplane?
We use the straw to suck soft drinks, why?
