Advertisements
Advertisements
प्रश्न
Classify the following into good conductors, resistors and insulators:
Rubber, Mercury, Nichrome, Polythene, Aluminium, Wood, Manganin, Bakelite, Iron, Paper, Thermocol, Metal coin
Advertisements
उत्तर
Conductors: mercury, aluminium, iron and metal coin
Resistors: nichrome and manganin
Insulators: rubber, polythene, wood, paper, thermocol and bakelite
APPEARS IN
संबंधित प्रश्न
Two conducting wires of the same material and of equal lengths and equal diameters are first connected in series and then parallel in a circuit across the same potential difference. The ratio of heat produced in series and parallel combinations would be:
A copper wire has diameter 0.5 mm and resistivity of 1.6 × 10−8Ω m. What will be the length of this wire to make its resistance 10 Ω? How much does the resistance change if the diameter is doubled?
Why are copper and aluminium wires usually employed for electricity transmission?
What is the general name of the substances having infinitely high electrical resistance?
What is meant by the "resistance of a conductor" ? Write the relation between resistance, potential difference and current.
What happens to the resistance as the conductor is made thinner?
Which among iron and mercury is a better conductor of electricity?
Which has more resistance:
a long piece of nichrome wire or a short one?
How does the resistance of a conductor depend on:
temperature of the conductor?
What would be the effect on the resistance of a metal wire of:
increasing its diameter?
How does the resistance of a wire change when:
its material is changed to one whose resistivity is three times?
How will you infer with the help of an experiment that the same current flows through every part of the circuit containing three resistors R1, R2 and R3 in series connected to a battery of V volts?
A cylindrical conductor of length l and uniform area of cross-section A has resistance R. Another conductor of length 2l and resistance R of the same material has an area of cross-section:
Assertion: Conductors allow the current to flow through themselves.
Reason: They have free charge carriers.
Use the data in the Table given below to answer the following –
Which material is the best conductor?
Table give below Electrical resistivity of some substances at 20°C
| Electrical resistivity of some substances at 20°C | ||
| − | Material | Resistivity (Ω m) |
| Conductors |
Silver | 1.60 × 10−8 |
| Copper | 1.62 × 10−8 | |
| Aluminium | 2.63 × 10−8 | |
| Tungsten | 5.20 × 10−8 | |
| Nickel | 6.84 × 10−8 | |
| Iron | 10.0 × 10−8 | |
| Chromium | 12.9 × 10−8 | |
| Mercury | 94.0 × 10−8 | |
| Manganese | 1.84 × 10−6 | |
| Alloys |
Constantan (alloy of Cu and Ni) |
49 × 10−6 |
| Manganin (alloy of Cu, Mn and Ni) |
44 × 10−6 | |
| Nichrome (alloy of Ni, Cr, Mn and Fe) |
100 × 10−6 | |
| Insulators | Glass | 1010 − 1014 |
| Hard rubber | 1013 − 1016 | |
| Ebonite | 1015 − 1017 | |
| Diamond | 1012 − 1013 | |
| Paper (dry) | 1012 | |
How will you infer with the help of an experiment that the same current flows through every part of the circuit containing three resistances in series connected to a battery?
