Advertisements
Advertisements
प्रश्न
Write down the expression for Stoke’s force and explain the symbols involved in it.
Advertisements
उत्तर
The viscous force F acting on a spherical body of radius r depends directly on:
- radius (r) of the sphere
- velocity (v) of the sphere and
- coefficient of viscosity η of the liquid
`["MLT"^-2] = "k"["ML"^-1"T"^-1]^"x" xx ["L"]^"y" xx ["LT"^-1]^"z"`
On solving, we get x = 1, y = 1 and z = 1.
Therefore, F = kη rv
Experimentally, Stoke found that the value of k = 6π
F = 6πη rv
This relation is known as Stoke’s law.
APPEARS IN
संबंधित प्रश्न
Estimate the speed of vertically falling raindrops from the following data. Radius of the drops = 0.02 cm, viscosity of air = 1.8 × 10−4 poise, g= 9.9 × 10 ms−2 and density of water = 1000 kg m−3.
A small sphere of radius 2 cm falls from rest in a viscous liquid. Heat is produced due to viscous force. The rate of production of heat when the sphere attains its terminal velocity is proportional to
An incompressible liquid flows through a unifonn cross sectional tube with velocity 20 cm/s. If the thickness of liquid layer is 0.8 cm then velocity of gradient of flow is ____________.
Analogy
Viscous force: ______:: Buoyant force: ______.
With increase in temperature, the viscosity of ______.
- gases decreases.
- liquids increases.
- gases increases.
- liquids decreases.
The velocity of a small ball of mass 0.3 g and density 8 g/cc when dropped in a container filled with glycerine becomes constant after some time. If the density of glycerine is 1.3 g/cc, then the value of viscous force acting on the ball will be x × 10-4 N, and the value of x is ______.
[use g = 10 m/s2]
A spherical solid ball of volume V is made of a material of density ρ1. It is falling through a liquid of density ρ2 (ρ2 < ρ1). Assume that the liquid applies a viscous force on the ball that is proportional to the square of its speed v, i.e., `"F"_"viscous"`= -kv2 (k > 0). The terminal speed of the ball is ______.
State and explain Newton's law of viscosity.
A force of 0.01 N is required to move a flat glass plate of area of 10 cm2 with a uniform velocity of 1 cm/ s over the surface of a liquid 2 mm thick. If the coefficient of viscosity of the liquid is 20 poise, the velocity gradient in the liquid layer is ______.
A water pipe with diameter of 5.0 cm is connected to another pipe of diameter 2.5 cm. How would the speeds of the water flow compare?
