Advertisements
Advertisements
प्रश्न
What is the maximum power in kilowatts of the appliance that can be connected safely to a 13 A ; 230 V mains socket?
Advertisements
उत्तर
Maximum power, P = VI
= `13Axx230 V`
= 2990 W = 2.99 kW
APPEARS IN
संबंधित प्रश्न
Which of the following terms does not represent electrical power in a circuit?
Calculate the cost of operating a heater of 500 W for 20 hours at the rate of Rs 3.90 per unit.
An electric heater of resistance 8 Ω takes a current of 15 A from the mains supply line. Calculate the rate at which heat is developed in the heater.
Which of the following is the most likely temperature of the filament of an electric light bulb when it is working on the normal 220 V supply line?
(a) 500°C
(b) 1500°C
(c) 2500°C
(d) 4500°C
Electrical power p is given by the expression P = (Q × V) ÷ time. Express the power P in terms of current and resistance explaining the meaning of symbols used there in.
Distinguish between kilowatt and kilowatt-hour.
When a current I flows through a resistance R for time t, the electrical energy spent is given by:
(a) IRt (b) I²Rt (c) `IR^2t` (d) `I^2R ⁄t`
A bulb with rating 250 V, 100 W is connected to a power supply of 220 V situated 10 m away using a copper wire of area of cross-section 5 mm2. How much power will be consumed by the connecting wires? Resistivity of copper = 1.7 × 10−8 Ωm
The diagram above shows a circuit with the key k open. Calculate :
(i) the resistance of the circuit when the key k is open.
(ii) the current drawn from the cell when the key k is open.
(iii) the resistance of the circuit when the key k is closed.
(iv) the current drawn from the cell when the key k is closed.
The diagram below shows a magnetic kept just below the conductor AB which is kept in North South direction.
(i) In which direction will the needle deflect when the key is closed ?
(ii) Why is the deflection produced ?
(iii) What will be the change in the deflection if the magnetic needle is taken just above the conductor AB ?
(iv) Name one device which works on this principle.
A potential difference of 6 V is applied across a 3 Ω resistor. What is the current flowinq throuqh the circuit?
A coil of copper wire is connected to a galvanometer. What would happen if a bar magnet is:
(i) Pushed into the coil with its north pole entering first?
(ii) Held at rest inside the coil?
(iii) Pulled out again?
Water in an electric kettle connected to a 220 V supply took 5 minutes to reach its boiling point. How long will it take if the supply voltage falls to 200 V?
Define Kilo watt hour.
State two advantages of filling an inert gas in an evacuated electric filament lamp.
How does the heat produced by die passage of current in a metallic wire depend on the current in the wire?
The resistance of filament of an electric heater is 500 Ω It is operated at 200V for 1 hour daily. Calculate the current drawn by the heater and the energy consumed in kWh, by the heater in a month of 30 days.
An electric appliance is rated at 1000 W, 250V. Calculate:
(i) The electrical energy consumed by the appliance in 12 hour.
(ii) The cost of energy consumed at Rs. 1.20 per kWh.
How long would this appliance take to use 1 kWh energy when operated at 250 V?
1 mV is equal to:
