हिंदी

If the effective current in a 50 cycle AC circuit is 5 A, what is the peak value of current? What is the current 1/600 after if was zero?

Advertisements
Advertisements

प्रश्न

If the effective current in a 50 cycle AC circuit is 5 A, what is the peak value of current? What is the current 1/600 after if was zero?

संख्यात्मक
Advertisements

उत्तर

Data: f = 50 Hz, irms = 5 A, t = `1/600`s

The peak value of the current,

`"i"_0 = "i"_"rms" sqrt2 = (5)(1.414) = 7.07`A

i = `"i"_0 sin (2pi"ft")`

`= 7.07 sin[2pi (50)(1/600)]`

`= 7.07 sin(pi/6) = (7.07)(0.5)`

= 3.535 A

shaalaa.com
  क्या इस प्रश्न या उत्तर में कोई त्रुटि है?
अध्याय 13: AC Circuits - Exercises [पृष्ठ ३०५]

APPEARS IN

बालभारती Physics [English] Standard 12 Maharashtra State Board
अध्याय 13 AC Circuits
Exercises | Q 12 | पृष्ठ ३०५

संबंधित प्रश्न

A 15.0 μF capacitor is connected to a 220 V, 50 Hz source. Find the capacitive reactance and the current (rms and peak) in the circuit. If the frequency is doubled, what will happen to the capacitive reactance and the current?


A capacitor of 100 μF, a coil of resistance 50Ω, and an inductance 0.5 H are connected in series with a 110 V-50Hz source. Calculate the rms value of current in the circuit.


Find the capacity of a capacitor which when put in series with a 10Ω resistor makes the power factor equal to 0.5. Assume an 80V-100Hz AC supply.


Find the time required for a 50 Hz alternating current to change its value from zero to the rms value.


State the average or mean value of an alternating emf? Obtain the expression for it.


State the rms value of an alternating current? Write the relation between the rms value and peak value of an alternating current that varies with time. 


Alternating current cannot be measured by D.C. ammeter because ____________.


An alternating voltage e = `200sqrt2` sin(100 t) volt is connected to a 1 µF capacitor through a.c. ammeter. The reading of the ammeter is ______


The rms value of current in a 50 Hz AC circuit is 6 A. The average value of AC current over a cycle is ____________.


An alternating voltage is given by E = 100 sin`(omega + pi/6)"V"`. The voltage will be maximum for the first time when is ______. [T = periodic time]


In half-wave rectifier, the RMS value of A.C. component of the wave is ____________.


Instrument which measures alternating current is based on ____________.


A 60 `Omega` electric heater is connected to a 200 V, 50 Hz mains supply. The peak value of electric current flowing in the circuit is approximately ______.


What is the r.m.s. value of an alternating current which when passed through a resistor produces heat which is four times of that produced by a direct current of 3 ampere in the same resistor?


The r.m.s. value of induced voltage in a coil of 25 turns each of area 30 sq. cm. rotating at 2000 r.p.m. about an axis at right angles to magnetic field is (B = 5 x 10-4 Wb/m2) ____________.


A 25 watt lamp is connected to a.c. potential of peak value 100 V. Calculate the rms value of the current.


An alternating voltage is given by e = 8sin628.4t. Find

  1. peak value of e.m.f.
  2. frequency or e.m.f.
  3. instantaneous value of e.m.f. at time t = 10. ms

The instantaneous voltage through a circuit of impedance \[10\Omega\] is V = 40sin \[(50\pi t).\] The effective value of current is ______.


A 10 µF capacitor is connected to a 210 V, 50 Hz source as shown in figure. The peak current in the circuit is nearly (π = 3.14):


An LCR circuit contains resistance of 110 Q and a supply of 220 V at 300 rad/s angular frequency. If only capacitance is removed from the circuit, current lags behind the voltage by 45°. If on the other hand, only inductor is removed the current leads by 45° with the applied voltage. The rms current flowing in the circuit will be ______.


An alternating e.m.f. is given by e = e0 sin ωt. In what time the e.m.f. will have value `e_0/sqrt 2`, if ‘e’ starts from zero?

`(sin 45^circ = 1/sqrt 2)`


Share
Notifications

Englishहिंदीमराठी


      Forgot password?
Use app×