Advertisements
Advertisements
प्रश्न
Describe the steps involved in magnetising an iron strip with the help of a magnet.
Advertisements
उत्तर
The following steps may be used to magnetise an iron strip using a magnet:
-
Lay down the required iron strip to be magnetised on a solid wood surface.
-
Place a bar magnet in your hands with one end on one edge of the strip and the other end on the other.
-
Move the magnet along the length of the strip without lifting it until you reach the opposite edge.
-
Repetition of the preceding stages.
-
Place the iron fillings on the strip and expand them. If it is attracted, the strip will become magnetised; if not, repeat the procedures a few times more.
APPEARS IN
संबंधित प्रश्न
You are provided with an iron needle. How will you magnetize it?
Take a glass of water with a few pins inside. How will you take out the pins without dipping your hands into water?
Analogy:
Electromagnet: Magnetic crane.
Ordinary magnet: ______.
What are the objects affected by a magnetic field?
Write a note on the Mangle train.
The arrangement to store two magnets is shown by figures (a), (b), (c) and (d) in the following figure. Which one of them is the correct arrangement?
In a bar magnet, magnetic attraction is ______ near its ends.
Four identical iron bars were dipped in a heap of iron filings one by one. Figure shows the amount of iron filings sticking to each of them.
- Which of the iron bar is likely to be the strongest magnet?
- Which of the iron bars is not a magnet? Justify your answer.
Four identical iron bars were dipped in a heap of iron filings one by one. Fig. 13.5 shows the amount of iron filings sticking to each of them.
Which of the iron bars is not a magnet? Justify your answer.
Boojho kept a magnet close to an ordinary iron bar. He observed that the iron bar attracts a pin as shown in the following figure.
What inference could he draw from this observation? Explain.
