Advertisements
Advertisements
प्रश्न
A scooter starting from rest moves with a constant acceleration for a time ∆t1, then with a constant velocity for the next ∆t2 and finally with a constant deceleration for the next ∆t3 to come to rest. A 500 N man sitting on the scooter behind the driver manages to stay at rest with respect to the scooter without touching any other part. The force exerted by the seat on the man is
विकल्प
500 N throughout the journey
less than 500 N throughout the journey
more than 500 N throughout the journey
> 500 N for time ∆t1 and ∆t3 and 500 N for ∆t2.
Advertisements
उत्तर
>500 N for time ∆t1 and ∆t3 and 500 N for ∆t2.
During the time interval ∆t2, the scooter is moving with a constant velocity, which implies that the force exerted by the seat on the man is 500 N (for balancing the weight of the man).
During the time interval ∆t1 and ∆t3, the scooter is moving with constant acceleration and deceleration, which implies that a frictional force is also applied. Therefore, the net force exerted by the seat on the man should be >500 N.
APPEARS IN
संबंधित प्रश्न
Can you accelerate a car on a frictionless horizontal road by putting more petrol in the engine? Can you stop a car going on a frictionless horizontal road by applying brakes?
Two cars of unequal masses use similar tyres. If they are moving at the same initial speed, the minimum stopping distance
In order to stop a car in shortest distance on a horizontal road, one should
Consider a vehicle going on a horizontal road towards east. Neglect any force by the air. The frictional force on the vehicle by the road
(a) is towards east if the vehicle is accelerating
(b) is zero if the vehicle is moving with a uniform velocity
(c) must be towards east
(d) must be towards west.
A care is going at a speed of 21.6 km/hr when it encounters at 12.8 m long slope of angle 30° (in the following figure). The friction coefficient between the road and the tyre is `1/2sqrt3`. Show that no matter how hard the driver applies the brakes, the car will reach the bottom with a speed greater than 36 km/hr. Take g = 10 m/s2.

A disc of mass M and radius R is placed a rough horizontal surface with its axis horizontal. A light rod of length '2R' is fixed to the disc at point 'A' as shown in figure and a force `3/2` Mg is applied at the other end. If disc starts to roll without slipping the value of "10 × µmin" where µmin is minimum coefficient of friction between disc and horizontal surface required for pure rolling is ______.

Friction between two bodies when one body is rolling over the other is called:
Which type of friction is the strongest?
The weakest form of friction among the three types is:
Which statement correctly orders the friction types from highest to lowest?
A flat tire is harder to roll than an inflated tire because:
Ball bearings are used in machines because they:
