Advertisements
Advertisements
प्रश्न
A closely wound solenoid of 2000 turns and area of cross-section 1.6 × 10–4 m2, carrying a current of 4.0 A, is suspended through its centre allowing it to turn in a horizontal plane.
- What is the magnetic moment associated with the solenoid?
- What is the force and torque on the solenoid if a uniform horizontal magnetic field of 7.5 × 10–2 T is set up at an angle of 30° with the axis of the solenoid?
Advertisements
उत्तर
Number of turns on the solenoid, n = 2000
Area of cross-section of the solenoid, A = 1.6 × 10−4 m2
Current in the solenoid, I = 4 A
- The magnetic moment along the axis of the solenoid is calculated as:
M = nAI
= 2000 × 1.6 × 10−4 × 4
= 1.28 Am2 - Magnetic field, B = 7.5 × 10−2 T
Angle between the magnetic field and the axis of the solenoid, θ = 30°
Torque, τ = MB sin θ
= 1.28 × 7.5 × 10−2 × sin 30°
= 4.8 × 10−2 Nm
Since the magnetic field is uniform, the force on the solenoid is zero.
The torque on the solenoid is 4.8 × 10−2 Nm.
APPEARS IN
संबंधित प्रश्न
An iron needle is attracted to the ends of a bar magnet but not to the middle region of the magnet. Is the material making up the ends of a bare magnet different from that of the middle region?
Two bar magnets are placed close to each other with their opposite poles facing each other. In absence of other forces, the magnets are pulled towards each other and their kinetic energy increases. Does it contradict our earlier knowledge that magnetic forces cannot do any work and hence cannot increase kinetic energy of a system?
A bar magnet of length 1 cm and cross-sectional area 1.0 cm2 produces a magnetic field of 1.5 × 10−4 T at a point in end-on position at a distance 15 cm away from the centre. (a) Find the magnetic moment M of the magnet. (b) Find the magnetisation I of the magnet. (c) Find the magnetic field B at the centre of the magnet.
An electron moves along +x direction. It enters into a region of uniform magnetic field `vec B` directed along −z direction as shown in fig. Draw the shape of the trajectory followed by the electron after entering the field.
Choose the correct option.
Inside a bar magnet, the magnetic field lines
Answer the following question in brief.
What happens if a bar magnet is cut into two pieces transverse to its length/along its length?
A closely wound solenoid of 800 turns and area of cross-section 2.5 × 10–4 m2 carries a current of 3.0 A. Explain the sense in which the solenoid acts like a bar magnet. What is its associated magnetic moment?
When iron filings are sprinkled on a sheet of glass placed over a short bar magnet then, the iron filings form a pattern suggesting that the magnet has ______.
In which case of comparing solenoid and bar magnet there is no exact similarity?
According to the dipole analogy 1/ε0 corresponds to ______.
Magnetic moment for solenoid and corresponding bar magnet is ______.
The magnetic moment of atomic neon is equal to
When current is double deflection is also doubled in
A proton has spin and magnetic moment just like an electron. Why then its effect is neglected in magnetism of materials?
Suppose we want to verify the analogy between electrostatic and magnetostatic by an explicit experiment. Consider the motion of (i) electric dipole p in an electrostatic field E and (ii) magnetic dipole m in a magnetic field B. Write down a set of conditions on E, B, p, m so that the two motions are verified to be identical. (Assume identical initial conditions.)
A bar magnet of magnetic moment m and moment of inertia I (about centre, perpendicular to length) is cut into two equal pieces, perpendicular to length. Let T be the period of oscillations of the original magnet about an axis through the midpoint, perpendicular to length, in a magnetic field B. What would be the similar period T′ for each piece?
Use (i) the Ampere’s law for H and (ii) continuity of lines of B, to conclude that inside a bar magnet, (a) lines of H run from the N pole to S pole, while (b) lines of B must run from the S pole to N pole.
Verify the Ampere’s law for magnetic field of a point dipole of dipole moment m = m`hatk`. Take C as the closed curve running clockwise along (i) the z-axis from z = a > 0 to z = R; (ii) along the quarter circle of radius R and centre at the origin, in the first quadrant of x-z plane; (iii) along the x-axis from x = R to x = a, and (iv) along the quarter circle of radius a and centre at the origin in the first quadrant of x-z plane.
A bar magnet is demagnetized by inserting it inside a solenoid of length 0.2 m, 100 turns, and carrying a current of 5.2 A. The coercivity of the bar magnet is ______.
