Advertisements
Advertisements
प्रश्न
Which property of a conducting wire is utilised in making electric fuse?
Advertisements
उत्तर
A conducting wire should have a low melting point if it is utilised in making an electric fuse.
APPEARS IN
संबंधित प्रश्न
Three resistors of resistances R1 , R2 and R3 are connected (i) in series, and (ii) in parallel. Write expressions for the equivalent resistance of the combination in each case.
Two identical resistros of `12 Omega` each are connected to a battery of 3V . Calculate the ratio of the power consumed by the resulting combinations with minimum resistance and maximum resistance.
Match the following
| 1. | Cell | used to open or close a circuit |
| 2. | Switch | safety device used in electric circuit |
| 3. | Circuit | A complete path for the flow of an electric current |
| 4. | Miniature circuit Breaker | Reset by hand, circuit becomes complete once again |
| 5. | Fuse | A device which converts chemical energy into electrical energy |
Explain the construction and working of an Telephone.
A cell, a resistor, a key and ammeter are arranged as shown in the circuit diagrams of Figure. The current recorded in the ammeter will be
 |
 |
 |
| (i) | (ii) | (iii) |
Name the effect of current responsible for the glow of the bulb in an electric circuit.
Draw the symbols of the following circuit components.
Electric bulb
Electricity produced on rubbing is ______.
Choose from the options a, b, c and d given in the following figure which shows the correct direction of current.
A torch is not functioning, though contact points in the torch are in working condition. What can be the possible reasons for this? Mention any three.
