#### Chapters

Chapter 2: Units and Measurements

Chapter 3: Motion in a Straight Line

Chapter 4: Motion in a Plane

Chapter 5: Laws of Motion

Chapter 6: Work, Energy and Power

Chapter 7: System of Particles and Rotational Motion

Chapter 8: Gravitation

Chapter 9: Mechanical Properties of Solids

Chapter 10: Mechanical Properties of Fluids

Chapter 11: Thermal Properties of Matter

Chapter 12: Thermodynamics

Chapter 13: Kinetic Theory

Chapter 14: Oscillations

▶ Chapter 15: Waves

###### Advertisements

###### Advertisements

## Solutions for Chapter 15: Waves

Below listed, you can find solutions for Chapter 15 of CBSE NCERT for Physics Class 11.

### NCERT solutions for Physics Class 11 Chapter 15 Waves Exercises [Pages 387 - 390]

A string of mass 2.50 kg is under a tension of 200 N. The length of the stretched string is 20.0 m. If the transverse jerk is struck at one end of the string, how long does the disturbance take to reach the other end?

A stone dropped from the top of a tower of height 300 m high splashes into the water of a pond near the base of the tower. When is the splash heard at the top given that the speed of sound in air is 340 m s^{–1}? (g= 9.8 m s^{–2})

A steel wire has a length of 12.0 m and a mass of 2.10 kg. What should be the tension in the wire so that speed of a transverse wave on the wire equals the speed of sound in dry air at 20 °C = 343 m s^{–1}.

Use the formula `v = sqrt((gamma P)/rho)` to explain why the speed of sound in air is independent of pressure.

Use the formula `v = sqrt((gamma P)/rho)` to explain why the speed of sound in air increases with temperature.

Use the formula `v = sqrt((gamma P)/rho)` to explain why the speed of sound in air increases with humidity.

You have learnt that a travelling wave in one dimension is represented by a function y= f (x, t)where x and t must appear in the combination x – v t or x + v t, i.e. y = f (x ± v t). Is the converse true? Examine if the following functions for y can possibly represent a travelling wave:

(a) `(x – vt )^2`

(b) `log [(x + vt)/x_0]`

(c) `1/(x + vt)`

A bat emits an ultrasonic sound of frequency 1000 kHz in the air. If the sound meets a water surface, what is the wavelength of the the reflected sound? The speed of sound in air is 340 m s^{–1} and in water 1486 m s^{–1}.

A bat emits an ultrasonic sound of frequency 1000 kHz in the air. If the sound meets a water surface, what is the wavelength of the transmitted sound? The speed of sound in air is 340 m s^{–1} and in water 1486 m s^{–1}.

A hospital uses an ultrasonic scanner to locate tumours in a tissue. What is the wavelength of sound in the tissue in which the speed of sound is 1.7 km s^{–1}? The operating frequency of the scanner is 4.2 MHz.

A transverse harmonic wave on a string is described by y(x, t) = 3.0 sin (36 t + 0.018 x + π/4)

Where x and y are in cm and t in s. The positive direction of x is from left to right.

(a) Is this a travelling wave or a stationary wave?

If it is travelling, what are the speed and direction of its propagation?

(b) What are its amplitude and frequency?

(c) What is the initial phase at the origin?

(d) What is the least distance between two successive crests in the wave?

For the wave described in Exercise 15.8, plot the displacement (*y*) versus (*t*) graphs for *x = *0, 2 and 4 cm. What are the shapes of these graphs? In which aspects does the oscillatory motion in travelling wave differ from one point to another: amplitude, frequency or phase?

For the travelling harmonic wave

y (x, t) = 2.0 cos 2π (10t – 0.0080x + 0.35)

Where x and y are in cm and t in s. Calculate the phase difference between oscillatory motion of two points separated by a distance of 4 m.

For the travelling harmonic wave

y (x, t) = 2.0 cos 2π (10t – 0.0080x + 0.35)

Where x and y are in cm and t in s. Calculate the phase difference between oscillatory motion of two points separated by a distance of 0.5 m.

For the travelling harmonic wave

y (x, t) = 2.0 cos 2π (10t – 0.0080x + 0.35)

Where x and y are in cm and t in s. Calculate the phase difference between oscillatory motion of two points separated by a distance of `λ/2`.

For the travelling harmonic wave

y (x, t) = 2.0 cos 2π (10t – 0.0080x + 0.35)

Where x and y are in cm and t in s. Calculate the phase difference between oscillatory motion of two points separated by a distance of `(3λ)/4`.

The transverse displacement of a string (clamped at its both ends) is given by

y(x, t) = 0.06 sin `2/3` x cos (120 πt)

where x and y are in m and t in s. The length of the string is 1.5 m and its mass is 3.0 × 10^{-2} kg.

Answer the following:

Does the function represent a travelling wave or a stationary wave?

The transverse displacement of a string (clamped at its both ends) is given by

y(x, t) = 0.06 sin `2/3` x cos (120 πt)

where x and y are in m and t in s. The length of the string is 1.5 m and its mass is 3.0 × 10^{-2} kg.

Answer the following:

Interpret the wave as a superposition of two waves travelling in opposite

directions. What is the wavelength, frequency, and speed of each wave?

The transverse displacement of a string (clamped at its both ends) is given by

y(x, t) = 0.06 sin `2/3` x cos (120 πt)

where x and y are in m and t in s. The length of the string is 1.5 m and its mass is `3.0 xx 10^(-2)` kg.

Answer the following :

Determine the tension in the string.

(i) For the wave on a string described in Exercise 15.11, do all the points on the string oscillate with the same (a) frequency, (b) phase, (c) amplitude? Explain your answers. (ii) What is the amplitude of a point 0.375 m away from one end?

Given below are some functions of x and t to represent the displacement (transverse or longitudinal) of an elastic wave. State which of these represent (i) a traveling wave, (ii) a stationary wave or (iii) none at all:

y = 2 cos (3x) sin (10t)

Given below are some functions of x and t to represent the displacement (transverse or longitudinal) of an elastic wave. State which of these represent (i) a traveling wave, (ii) a stationary wave or (iii) none at all:

`"y" = 2sqrt(x - "vt")`

Given below are some functions of x and t to represent the displacement (transverse or longitudinal) of an elastic wave. State which of these represent (i) a traveling wave, (ii) a stationary wave or (iii) none at all:

y = 3 sin (5x – 0.5t) + 4 cos (5x – 0.5t)

y = cos x sin t + cos 2x sin 2t

A wire stretched between two rigid supports vibrates in its fundamental mode with a frequency of 45 Hz. The mass of the wire is 3.5 × 10^{–2} kg and its linear mass density is 4.0 × 10^{–2} kg m^{–1}. What is (a) the speed of a transverse wave on the string, and (b) the tension in the string?

A metre-long tube open at one end, with a movable piston at the other end, shows resonance with a fixed frequency source (a tuning fork of frequency 340 Hz) when the tube length is 25.5 cm or 79.3 cm. Estimate the speed of sound in air at the temperature of the experiment. The edge effects may be neglected.

A steel rod 100 cm long is clamped at its middle. The fundamental frequency of longitudinal vibrations of the rod is given to be 2.53 kHz. What is the speed of sound in steel?

A pipe 20 cm long is closed at one end. Which harmonic mode of the pipe is resonantly excited by a 430 Hz source? Will the same source be in resonance with the pipe if both ends are open? (Speed of sound in air is 340 m s^{–1}).

Two sitar strings A and B playing the note ‘*Ga*’ are slightly out of tune and produce beats of frequency 6 Hz. The tension in the string A is slightly reduced and the beat frequency is found to reduce to 3 Hz. If the original frequency of A is 324 Hz, what is the frequency of B?

Explain why (or how) In a sound wave, a displacement node is a pressure antinode and vice versa,

Explain why (or how): Bats can ascertain distances, directions, nature, and sizes of the obstacles without any “eyes”,

Explain why (or how) A violin note and sitar note may have the same frequency, yet we can distinguish between the two notes,

Explain why (or how) Solids can support both longitudinal and transverse waves, but only longitudinal waves can propagate in gases

Explain why (or how) The shape of a pulse gets distorted during propagation in a dispersive medium.

A train, standing at the outer signal of a railway station blows a whistle of frequency 400 Hz in still air. (i) What is the frequency of the whistle for a platform observer when the train (a) approaches the platform with a speed of 10 m s^{–1}, (b) recedes from the platform with a speed of 10 m s^{–1}? (ii) What is the speed of sound in each case? The speed of sound in still air can be taken as 340 m s^{–1}.

A train, standing in a station-yard, blows a whistle of frequency 400 Hz in still air. The wind starts blowing in the direction from the yard to the station with at a speed of 10 m s^{–1}. What are the frequency, wavelength, and speed of sound for an observer standing on the station’s platform? Is the situation exactly identical to the case when the air is still and the observer runs towards the yard at a speed of 10 m s^{–1}? The speed of sound in still air can be taken as 340 m s^{–1}.

#### Additional Exercises

A travelling harmonic wave on a string is described by

`y(x,t) = 7.5 sin (0.0050x + 12t + pi/4)`

(a) What are the displacement and velocity of oscillation of a point at *x *= 1 cm, and *t =*1 s? Is this velocity equal to the velocity of wave propagation?

(b) Locate the points of the string which have the same transverse displacements and velocity as the *x = *1 cm point at *t = *2 s, 5 s and 11 s.

A narrow sound pulse (for example, a short pip by a whistle) is sent across a medium. (a) Does the pulse have a definite (i) frequency, (ii) wavelength, (iii) speed of propagation? (b) If the pulse rate is 1 after every 20 s, (that is the whistle is blown for a split of second after every 20 s), is the frequency of the note produced by the whistle equal to 1/20 or 0.05 Hz

One end of a long string of linear mass density 8.0 × 10^{–3} kg m^{–1} is connected to an electrically driven tuning fork of frequency 256 Hz. The other end passes over a pulley and is tied to a pan containing a mass of 90 kg. The pulley end absorbs all the incoming energy so that reflected waves at this end have negligible amplitude. At *t *= 0, the left end (fork end) of the string *x *= 0 has zero transverse displacement (*y *= 0) and is moving along positive *y*-direction. The amplitude of the wave is 5.0 cm. Write down the transverse displacement *y *as the function of *x *and *t *that describes the wave on the string.

A SONAR system fixed in a submarine operates at a frequency 40.0 kHz. An enemy submarine moves towards the SONAR with a speed of 360 km h^{–1}. What is the frequency of sound reflected by the submarine? Take the speed of sound in water to be 1450 m s^{–1}.

Earthquakes generate sound waves inside the earth. Unlike a gas, the earth can experience both transverse (*S*) and longitudinal (*P*) sound waves. Typically the speed of *S *wave is about 4.0 km s^{–1}, and that of *P *wave is 8.0 km s^{–1}. A seismograph records *P *and *S *waves from an earthquake. The first *P *wave arrives 4 min before the first *S *wave. Assuming the waves travel in straight line, at what distance does the earthquake occur?

A bat is flitting about in a cave, navigating via ultrasonic beeps. Assume that the sound emission frequency of the bat is 40 kHz. During one fast swoop directly toward a flat wall surface, the bat is moving at 0.03 times the speed of sound in air. What frequency does the bat hear reflected off the wall?

## Solutions for Chapter 15: Waves

## NCERT solutions for Physics Class 11 chapter 15 - Waves

Shaalaa.com has the CBSE Mathematics Physics Class 11 CBSE solutions in a manner that help students grasp basic concepts better and faster. The detailed, step-by-step solutions will help you understand the concepts better and clarify any confusion. NCERT solutions for Mathematics Physics Class 11 CBSE 15 (Waves) include all questions with answers and detailed explanations. This will clear students' doubts about questions and improve their application skills while preparing for board exams.

Further, we at Shaalaa.com provide such solutions so students can prepare for written exams. NCERT textbook solutions can be a core help for self-study and provide excellent self-help guidance for students.

Concepts covered in Physics Class 11 chapter 15 Waves are Speed of Wave Motion, Reflection of Transverse and Longitudinal Waves, Displacement Relation for a Progressive Wave, The Speed of a Travelling Wave, Principle of Superposition of Waves, Introduction of Reflection of Waves, Standing Waves and Normal Modes, Beats, Doppler Effect, Wave Motion.

Using NCERT Physics Class 11 solutions Waves exercise by students is an easy way to prepare for the exams, as they involve solutions arranged chapter-wise and also page-wise. The questions involved in NCERT Solutions are essential questions that can be asked in the final exam. Maximum CBSE Physics Class 11 students prefer NCERT Textbook Solutions to score more in exams.

Get the free view of Chapter 15, Waves Physics Class 11 additional questions for Mathematics Physics Class 11 CBSE, and you can use Shaalaa.com to keep it handy for your exam preparation.